Description
A detachable bayonet mount for an airsoft rifle, useful for games with rules for close quarters fighting. The intended use is for Cyma CM350 3-shot shotgun, with ESP’s soft training dagger knife (TK-01-S). The knife belt sheathe was tested only for this knife, it will likely not fit other types.
Additional parts you’ll need for assembly:
2x M3x20 bolts
2x M3x30 bolts
2x 20mm long spring that will fit around M3 bolt (springs from click pens will work ok)
2x M3 square nut (optional, use MountV2_woNuts.stl if you can’t source them)
2x M3 hex nut
What to print (PETG):
1x RifleMountV2.stl (or RifleMountV2_woNuts.stl if you don’t have the square nuts)
1x RiflePin.stl
1x KnifeMountRail.stl
2x KnifeMountRing.stl
1x KnifeSheathe.stl if you have the ESP training dagger
What to print (TPU):
1x Rifle_TPU_Oring.stl
-This is an optional part, the RifleMountV2 will fit the CM350 by itself by friction. The O-ring will make the RifleMountV2 stick more reliably. The O-ring can also be rescaled to make the mount fit other airsoft guns.
Assembly: see the attached pictures.
The RifleMount and Pin use the square nuts, springs and 20mm bolts. The pin has to be inserted with the screws partially pulled out, and the pin has to be at a small angle. Once inserted into the RifleMount, tighten the bolts so the face of the Pin and face of the Mount are flush. If you tighten them too much the Pin will not have enough space to move around and hold the bayonet rail in place.
The bayonet holder uses the 30mm bolts and hex nuts. Push the Rings around the end of the knife and just behind the crossguard, push the Rail into the Rings and tighten with the bolts.
