Car body

£27.63

Taking only 20 minutes to scan the whole car, and just under one and a half hours to process the captured 3D data, this highly accurate 3D model was ready in under two hours from start to finish.

SKU: 2846398d34f6 Category:

Description

Sitting behind the wheel of a Mercedes E350, you could (technically) drive at a speed of 150 mph. Thanks to Artec Leo, this sprayed-down body of a Mercedes E350 was scanned in just 20 minutes, and ready as a 3D model only an hour and a half later.

Designed for larger objects, Leo’s job started with the hood of the car, followed by the individually scanned sides. The scan wrapped up with the trunk of the car, and after processing the captured 3D data, the job was done: A full scan of the entire vehicle resulting in a highly accurate 3D model ready to go in less than two hours.

3D printing settings


Layer Resolution: 0.2 mm for a balance of quality and speed.

Extruder Temperature: 200°C for PLA, 230°C for ABS. (Adjust for material.)

Print Speed: 50-60 mm/sec for optimal surface quality.

Supports: Use for complex parts, set density at 15-20%.

Bed Adhesion: Use glue or tape to prevent warping.

Infill: 20% for regular models, 100% for extra strength if needed.

Related products