Description
A very simple part to scan and a good example of scanning holes. To scan a hole, one needs to make sure that all or at least most of the edge area is seen by the scanner during the scanning process.
Ball joint
£6.60
A very simple part to scan and a good example of scanning holes.
3D printing settings
Layer Resolution: 0.2 mm for a balance of quality and speed.
Extruder Temperature: 200°C for PLA, 230°C for ABS. (Adjust for material.)
Print Speed: 50-60 mm/sec for optimal surface quality.
Supports: Use for complex parts, set density at 15-20%.
Bed Adhesion: Use glue or tape to prevent warping.
Infill: 20% for regular models, 100% for extra strength if needed.
