Description
This small turbine was scanned in three passes using a rotating table вАФ this enabled the operator to easily capture all the curves from different angles with less hand motion.
Turbine
£21.08
This small turbine was scanned in three passes using a rotating table вАФ this enabled the operator to easily capture all the curves from different angles with less hand motion.
3D printing settings
Layer Resolution: 0.2 mm for a balance of quality and speed.
Extruder Temperature: 200°C for PLA, 230°C for ABS. (Adjust for material.)
Print Speed: 50-60 mm/sec for optimal surface quality.
Supports: Use for complex parts, set density at 15-20%.
Bed Adhesion: Use glue or tape to prevent warping.
Infill: 20% for regular models, 100% for extra strength if needed.
