Description
Midcap insert for airsoft FAL magazines. Holds approx. 100rds depending on spring length.
Includes an outer shell that *should* work and allow you to print additional magazines instead of converting a hicap.
FAL Magazine MidCap Insert
£23.19
Midcap insert for airsoft FAL magazines. Holds approx. 100rds depending on spring length.
Includes an outer shell that *should* work and allow you to print additional magazines instead of converting a hicap.
3D printing settings
PDF with assembly instructions and additional print settings is included.
Recommended print settings
We used Fillamentum PLA but anything should work.
0.15mm or 0.20mm layer height, 15% rectilinear infill, 2 perimeters for the two large parts. Use 100% infill for top piece and small parts.
0.6mm nozzle for everything but 0.4mm should work fine too.
Does require some supports but they're very easy to remove. This applies to screw holes, top piece and follower.
Make sure you avoid underextrusion and print at a reasonably high temperature for the filament to improve durability.
Two different followers are included. Both work but you may find that one works better than the other.
